All our belts are custom measured and cut for you. Because of this they cannot be returned. Please make sure you give us the correct size.
The size will always be the length from the end of the buckle to the center hole. The diagram below illustrates this.
Two ways to tell us what size belt you need:
1. Measure one of your existing belts
This is the best way if possible.
Do not include the buckle itself, just measure the very end of the leather on the buckle side, to the hole you like the most (see diagram). This is the length you should order from us. Please round all numbers to the nearest 1/2” or CM
NOTE: if your belt is very thin or stretchy please add 1/2” (10mm). Our belts are made from 4.5-5mm thick leather.
Please see diagram below.
2. Second Method: add 2.5” (6cm) to your waist trousers size
For example: if you normally wear a size 30” trousers in the waist, then order a 32.5” belt. If your 30” trousers are snug, you might be closer to 31”, so order a 33.5.”
Remember, you can wear a belt that is slightly long, but not too short! If in doubt, please give us a slightly longer measurement.
Overall length and number of holes.
The length you order is not the overall length of the belt. To insure a good fit we always measure to the center hole, not to the tip of the belt.
Here’s an example of overall length and length between holes:
Example of overall length and length between holes:
|Size you ordered||# of holes||Space between holes||Length in addition to ordered size||Total length|
We normally put 7 holes with 1” (2.5 cm) spacing. This should give you plenty of adjustment.
If you have any questions or need help with the correct size, please do not hesitate to contact us.